Filter
Top Products
CHAPTER 5: THE MM-10ACX SUBWOOFER
32
MM-10ACX SATELLITE CONFIGURATIONS
Single Channel
To configure a single-channel satellite system with one
MM-10ACX and either one MM-4XP or one UP-4XP:
1. Connect a single audio signal to Audio In for Satellite 1
on the MM-10ACX.
2. Connect Satellite 1 Out from the MM-10ACX to the loud-
speaker input of the MM-4XP or UP-4XP.
3. Set the Input Select switch on the MM-10ACX to
SUM CH 1+2 (up).
4. If necessary, to accommodate for the placement of the
subwoofer and satellite loudspeaker, adjust the Input
Polarity switch and Gain knob on the MM-10ACX.
NOTE: The MM-10ACX can power up to two
MM-4XPs, or a single UP-4XP (due to its
higher power requirements and current draw).
MM-10ACX Single-Channel Satellite System (Shown with EN3 Connectors)
AC power
to AC Input
Balanced audio,
single channel, to
Audio In Satellite 1
Satellite 1 Out to MM-4XP (or UP-4XP)
(Balanced audio, 48 V DC)