Filter
Top Products
MM-10 OPERATING INSTRUCTIONS
45
6. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.
7. Reassemble the EN3 5-pin female connector:
■ Align the coupling ring’s side notches with the cord connector’s side notches and slide the couple ring onto the cord
connector.
■ Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable
clamps in the cable clamp housing into their compartments.
■ Slide the boot forward so it covers the cable clamp housing completely.
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
When connecting MM-10XP loudspeakers equipped with Phoenix connectors to the MPS-488HPp power supply, you need
a Phoenix 5-pin female to Phoenix 5-pin female cable. The following procedure documents how to assemble this cable.
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1” and then strip the black,
red, blue, and white wires by .275”.
Pin Destinations for EN3 5-Pin Female Cable Mount Connector
Assembled Phoenix-to-Phoenix Cable
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
Pin #2, Red,
48 V DC (+)
Pin #1, Black,
48 V DC (–)
Pin #3, Unshielded,
audio shield
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
REAR
FRONT
Dimple identifies Pin #1
1”
0.275”