Filter
Top Products
41
APPENDIX C: PHOENIX AND EN3 CABLE ASSEMBLY
ASSEMBLING EN3-TO-EN3 LOUDSPEAKER CABLES
When connecting MM-10XP loudspeakers equipped with EN3 connectors to the MPS-488HPe power supply, you need an
EN3 5-pin female to EN3 5-pin male cable. The following procedure documents how to assemble this cable. If you are start-
ing with an EN3-to-pigtail cable (included with the MM-10XP), you can skip step 5 in this procedure.
NOTE: Cable mount connectors cannot connect to other cable mount connectors. Cable mount connectors
can only connect to panel mount connectors (like those on the MM-10XP and MPS-488HPe) or inline connec-
tors. To extend cables with EN3 connectors on both ends you can use an EN3 5-pin female-to-male cable coupler.
To assemble an EN3-to-EN3 loudspeaker cable:
1. Disassemble the EN3 5-pin male connector and feed one end of the cable through the boot, cable clamp housing, and
coupling ring.
Assembled EN3-to-EN3 Cable
Disassembled EN3 5-Pin Male Cable Mount Connector
Cable clamp
housing
Boot Coupling ring
Cord connector