Filter
Top Products
SECTION FOUR - Service/Maintenance
Page 58 961 INSTALLATION MANUAL Revision A
Processor serial number and software revision
The serial number of the processor is affixed to the back of the unit, and
also has been permanently programmed into the unit’s database. You can
view this serial number at the
PRODUCT INFORMATION
screen in the
PROCESSOR SN/REV
field.
Serial numbers ending with the letter
D
indicate that the unit contains an
internal DGPS differential receiver.
Beacon receiver self-test and software revision
The 961 automatically self-tests the internal beacon receiver, if installed,
each time you power-up the unit. The
BCN RCVR ST/ REV
field displays
the software version used by your 961’s DGPS receiver (if installed), as
well as the self-test message
PASS
or
FAIL
. If all test parameters are met,
the field says
PA S S
. If the differential receiver fails any of the test criteria,
the field says
FAIL
. If the field says
FAIL
, the 961 won’t be receiving DGPS
signals; for details about troubleshooting the DGPS receiver, see ”Testing
and troubleshooting the 961” beginning on page 32. In many cases, the
reason for the failure is an open or shorted antenna cable, which can be
repaired in the field. If this isn’t the source of the failure, call the North-
star Service Department for further instructions.
If a beacon receiver isn’t installed, this field is blank.
GPS receiver self-test and software revision
The
GPS RCVR ST/REV
field displays the software version used by your
961’s GPS receiver, as well as the self-test message
PA S S
or
FAILED
. This
field should read
PASS
, not
FAIL
. If the 961 displays the message
FAIL
,
return the 961 to Northstar for service.
Configuring the
receivers
The 961’s
RECEIVER INFORMATION
screen provides you with access to
several of the 961’s GPS and DGPS (if installed) receiver functions. To dis-
play these functions, press the
STAR
key until you reach the
SERVICE
MENU
screen, then press the
RECEIVER SETUP
key.