Filter
Top Products
37
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the receiver
Notes:
• Only analog input sources are output by Zone 2.
Digital input sources are not output. If no sound is
heard when an input source is selected, check to make
sure it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change RI functions do not work.
Controlling Zone 2 with the Remote
Controller
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Zone 2 Sel: Source”
appears.
To select AM or FM, press the
[TUNER] Input Selector button
repeatedly. On the North American
model, you can also select
XM/SIRIUS.
Note:
• You cannot select different AM or
FM radio stations for your main
room and Zone 2. The same AM/FM
radio station will be heard in each
room.
2
To turn off Zone 2, press the Zone
2 [OFF] button.
ZONE 2 LEVEL/TONE
OFF
ZONE 2
1
Press the [ZONE 2] button, then
point the remote controller at the
receiver and press the
[ON/STANDBY] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [ZONE 2]
button, followed by an Input
Selector button.
To select AM or FM press the
[TUNER] Input Selector button
repeatedly. On the North American
model, you can also select
XM/SIRIUS.
Note:
• You cannot select different AM or
FM radio stations for your main
room and Zone 2. The same AM/FM
radio station will be heard in each
room.
ON/STANDBY
ZONE 2
/
MUTING
VOL
Input
selector
buttons