Filter
Top Products
44
Controlling Other Components—Continued
By default, the [DVD], [CD], and [DOCK] REMOTE
MODE buttons have been programmed with the remote
control codes for controlling Onkyo products. To control
the components connected via RI, follow the steps below
to program the appropriate remote control code for the
component to be used.
When a correct code is entered:
The REMOTE MODE button quickly flashes twice, and
programming completes.
When an incorrect code is entered or an incorrect
button is pressed:
The REMOTE MODE button flashes once, and
programming fails. Repeat steps 1 and 2.
Remote control codes for controlling components
connected via RI:
[DVD]: 5002 (5001 by default)
[CD]: 6002 (6001 by default)
[DOCK]: 9002 (9001 by default)
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Programming a remote control code for
controlling components connected via RI
1
Press and hold the [DVD], [CD],
or [DOCK] REMOTE MODE
button along with the [AUDIO]
button for more than three
seconds.
2
Select an appropriate 4-digit
code from the list provided
below, and then enter the code
using the number buttons while
the REMOTE MODE button is lit
(for approximately 30 seconds).
and
(3 seconds or more)
1
While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[DISPLAY] button until the button
REMOTE MODE button lights up
(about 3 seconds).
2
Press the REMOTE MODE button
again.
The
REMOTE MODE button
flashes
twice, indicating that the button has
been reset. Each REMOTE MODE
button is preprogrammed with a remote
control code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down the
[RECEIVER] REMOTE MODE
button, press and hold down the
[DISPLAY] button until the
REMOTE MODE button lights up
(about 3 seconds).
2
Within 30 seconds, press the
[RECEIVER] REMOTE MODE
button again.
The REMOTE MODE button flashes
twice, indicating that the remote
controller has been reset.
and
(3 seconds)
and
(3 seconds)