Onkyo TX-SR602 Car Stereo System User Manual


 
44
First Time Setup
—Continued
Minimum Speaker Impedance
(not American models)
If the impedance of any of the connected speakers is 4
ohms or more, but less than 6 ohms, set the Minimum
Speaker Impedance to “4 ohms.”
Note:
Before you change this setting, turn down the volume.
Notes:
This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 39).
2–4
1, 5
2, 3
1
RECEIVER
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “3. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
(Menus vary depending on country.)
4
Use the Up and Down [ ]/[ ]
buttons to select “b. Sp Imped-
ance Minimum,” and then use the
Left and Right [ ]/[ ] buttons to
select:
4 ohms:
Select if the impedance of any
connected speaker is 4 ohms
or more, but less than 6 ohms.
6 ohms:
Select if the impedances of all
connected speakers are
between 6 and 16 ohms.
5
Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
ENTER
ENTER
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input
1-3.Hardware Setup
------------------------
:Not Activated
b.Sp Impedance Minimum
:6ohms
c.TV Format :NTSC
d.AM Frequency Step
: 9kHz
a.Powered Zone2
ENTER