Filter
Top Products
67
Advanced Operation
—Continued
AV Recording
You can record AV input sources to an AV recording
component (VCR, etc) connected to the VIDEO 1 OUT
or VIDEO 2 OUT. See pages 27–38 for information on
connecting components.
Recording Separate AV Sources
Here you can record audio and video from completely
separate sources, allowing you to overdub audio onto
your video recordings. This function takes advantage of
the fact that when an audio-only input source (i.e.,
TAPE, TUNER, or CD) is selected, the video input
source remains unchanged.
In the following example, audio from the CD player con-
nected to the CD IN, and video from the camcorder con-
nected to the VIDEO 4 INPUT VIDEO jack are recorded
by the VCR connected to the VIDEO 1 OUT jacks.
1
Use the input selector buttons to
select the AV component that
you want to record.
Audio signals from the selected input
source are output by the VIDEO 1 OUT
and VIDEO 2 OUT only.
You can watch the source while record-
ing, and the AV receiver’s VOLUME
control has no effect on recording.
2
Start recording on the AV compo-
nent connected to the VIDEO 1
OUT or VIDEO 2 OUT.
3
Start playback on the source AV
component.
If you select another input source dur-
ing recording, that input source will be
recorded.
1
1
Prepare the camcorder and CD player for
playback.
2
Prepare the VCR for recording.
3
Press the [VIDEO 4] input selector button.
4
Press the [CD] input selector button.
This selects the CD player as the audio source, but
leaves the camcorder as the video source.
5
Start recording on the VCR and start play-
back on the camcorder and CD player.
The video from the camcorder and the audio from
the CD player are recorded by the VCR.
Camcorder
VCRCD player
video signal
audio signal