Filter
Top Products
9
Relocating the main controls
The main controls can be relocated to the bottom surface or right panel of the monitor depending on such factors as where
and how the monitor will be used.
<Note>
Before relocating the main control, make absolutely sure that the power has been turned off.
1
Disconnect the cord connecting the main controls to the
main unit.
Take hold of this part
and pull it free to
disconnect the cable.
Plug in the connector
until it clicks into place.
3
Remove the two screws, and remove the main controls
from the main unit. These two screws cannot be
removed from the main controls themselves.
4
Use the two screws to secure the main controls to the
right panel.
2
6
Remove the screws on the right panel of the main unit.
Secure the two screws, which were removed in step
2, in
the screw holes on the bottom of the monitor.
5
Plug the cord connecting the main controls into the
connector on the main unit and secure it.
<Note>
Using too much force to plug in the cord at the wrong
insertion angle may damage the pins inside. Check out
the shape of the connector before plugging it in.