Filter
Top Products
CQ-C7205U/C7105U
15
English
XM Receiver
1
Press [SOURCE] to select the XM
Satellite Radio mode.
2
Press [BAND] to select a band.
Notes:
¡Connect the optional XM receiver (XMD-1000).
¡To connect the XM receiver (XMD-1000), it is
required to use an optional extension cord that is
produced by XM exclusively for Panasonic prod-
ucts.
¡“RADIO ID” is displayed with channel 0.
¡“UPDATING” is displayed during the update of the
identification code.
¡“LOADING” is displayed during the acquisition of
audio data or information.
3
Select a channel.
Channel selection
[]] (TUNE): Preceding channel
[[] (TUNE): Next channel
Preset channel selection
[{] (P-SET: Preset): Lower preset channel
[}] (P-SET: Preset): Higher preset channel
Notes:
¡ Direct selection can be executed with [1] to [6]
buttons on remote control.
¡ A preset station is selectable by turning [VOL]
and pressing [PUSH SEL] while the preset list
screen is present on the monitor.
¡ The volume is not adjustable while the preset list
screen is present on the monitor.
Up to 6 channels can be preset in XM1 to XM3
respectively.
Preset
channels
can be simply called up by pressing [}]
(P-SET) or [{] (P-SET).
Note: Direct selection can be executed with [1] to [6]
buttons on remote control.
1
Tune into a channel.
2
Hold down [}] or [{] for 2 sec. or
more.
3
Turn [VOL] to select a preset number.
4
Hold down [PUSH SEL] for 2 sec. or
more, and the channel is written on the
selected preset number.
Preset number/channel number blinks once.
Notes:
¡In step 2, a channel can be registered by holding
down the numeric button [1] to [6] for 2 sec. or more.
¡To stop presetting channels, press [DISP: DISPLAY].
¡The operation above allows users to replace the cur-
rent channel with the channel preset in the selected
number while selecting a preset channel.
¡The channel may be different between when the chan-
nel is preset and when the channel is called up
because channel preset is performed using Service ID.
XM Receiver
Mode Display
Artist name/Song title
Band
Preset Number
Channel number/name
indicates the satellite
receiver is ready.
Operation FlowChannel Preset
(P-SET: PRESET)