Filter
Top Products
16
RQT9756
≥ If broadcasting stations are memorised, proceed to
“To re-scan DAB/DAB+ stations” to memorise stations on
other frequency blocks. (l 14)
≥ If “SCAN FAILED” is still displayed, repeat steps 1 to 3 until a
station is memorised. If the situation does not improve, try
using an outdoor DAB antenna or consult your dealer.
∫ Checking the DAB/DAB+ signal
reception quality
1 While listening to the DAB broadcast:
Press [PLAY MENU] repeatedly to select “SIGNAL
QUALITY” and then press [OK].
≥ The current frequency block is displayed and
then the reception quality is indicated.
2 If the signal reception quality is poor, move the
antenna to a position where the reception quality
improves.
3 To continue checking the quality of other frequency
blocks:
Press [3, 4] again and select the desired
frequency.
4 Press [OK] to exit.
≥ If the antenna has been adjusted, perform auto scanning and
update the station memory. (l 14)
Only the frequencies currently used in your region as
of January 2013 on BAND III are Auto scanned
(“LOCAL”, factory setting).
Select “ALL BAND III” when you want to store stations
on other frequencies to memory.
1 Press [PLAY MENU] repeatedly to select
“SCANMODE”.
2 Press [3, 4] to select “ALL BAND III” or “LOCAL”
and then press [OK].
≥ The “DAB AUTO SCAN” begins automatically.
≥ The DAB preset channels are erased when the
“SCANMODE” is changed.
≥ If the play timer has been set and DAB/DAB+ is the music
source, the timer switches off. (l 18)
Preparation
≥ Turn the unit on.
≥ A station previously stored is overwritten when another
station is stored in the same channel preset.
1 Press [PLAY MENU] to select “A.PRESET”.
2 Press [3, 4] to select “LOWEST” or “CURRENT”
and then press [OK].
LOWEST:
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to “Manual tuning and
presetting”.
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Preparation
1 Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2 Press [3, 4] to select “PRESET” and then press
[OK].
Press [:/6] or [5/9] to select the channel.
Changing the Auto scan frequency
range
Reception quality
0 (poor) – 8 (excellent)
Listening to FM radio
You can preset up to 30 channels.
≥ Make sure that the antenna is connected. (l 5)
≥ Press [RADIO] to select “FM”.
Presetting stations automatically
To begin auto preset with the lowest frequency
(FM 87.50).
Listening to a preset channel
SC-HC58DBEB_DBGN_GS~RQT9756-B.book 16 ページ ２０１３年１月２９日 火曜日 午前１０時１２分