Filter
Top Products
25
Main Menu
Volume
Main Menu Settings
The Main Menu is divided into six sections, accessible by scrolling
right or left through the Main Menu options using the navigation
encoder (Fig. 13). Each menu item displays its current status. Press
the encoder over the selection to edit.
MODE
The IPR
™
DSP has the capability of routing the signal coming into
input A to both ampliers A and B for Mono operation (Fig. 14).
In Mono mode, both channels will receive the signal coming in
from channel A. In Stereo mode, each channel will receive and
independent input. Amplier A will use input A, and amplier B will
use input B (Fig. 15).
Keep in mind the 1/4” thru outputs can be used to route their
respective input signals to other to other ampliers. This is
extremely helpful when in sound systems with ampliers.
To preserve the balanced input when using the thru output, use
a TRS (stereo) 1/4" cable to route the "thru" signal to another
balanced input.
Volume:
The Main Menu displays the current settings for the volume
controls (0 being maximum) (Fig. 16)
NOTE
: The volume controls are really input attenuators and are
controlled by DSP.
Whenever possible, set the attenuators to maximum (0) to maintain
optimum system headroom. The input attenuator controls, located on
the front panel (one for channel A, one for channel B), adjust gain for
their respective amplifier channels in all modes. See the specifications
at the end of this manual for standard voltage gain and input sensitivity
information.
Scroll through menu using navigation encoder
Fig. 13
Fig. 14
Fig. 15
Fig. 16
25