Philips 32PFL3615/77 Car Satellite TV System User Manual


 
28
If there are intermittent sound
disruptions, check that output settings
from the HDMI device are correct.
If you use an HDMI-to-DVI adapter
or HDMI to DVI cable, check that an
additional audio cable is connected to
AUDIO IN (mini-jack only).
Computer connection issues
The computer display on the TV is not stable:
Check that your PC uses the supported
resolution and refresh rate.
Set the TV picture format to unscaled.
Contact us
If you cannot resolve your problem, refer to
the FAQs for this TV at www.philips.com/
support.
If the problem remains unresolved, contact
Philips Consumer Care in your country as
listed in this user manual.
Warning
Do not attempt to repair the TV yourself. This
may cause severe injury, irreparable damage to
your TV or void your warranty.
Note
Make a note of your TV model and serial
number before you contact Philips. These
numbers are printed on the back of the TV
and on the packaging.
The TV did not save your picture settings:
Check that the TV location is set to the
home setting. This mode offers you the
Á exibility to change and save settings.
The picture does not À t the screen; it is too
big or too small:
Try using a different picture format.
The picture position is incorrect:
Picture signals from some devices may
not À t the screen correctly. Check the
signal output of the device.
Sound issues
There is picture but no sound from the TV:
Note
If no audio signal is detected, the TV
automatically switches the audio output off
— this does not indicate malfunction.
Check that all cables are properly
connected.
Check that the volume is not set to 0.
Check that the sound is not muted.
There is picture but sound quality is poor:
Check that the sound settings are
correctly set.
There is picture but sound comes from one
speaker only:
Verify that sound balance is set to the
center.
HDMI connection issues
There are problems with HDMI devices:
Note that HDCP (High-bandwidth Digital
Content Protection) support can delay
the time taken for a TV to display content
from a HDMI device.
If the TV does not recognize the HDMI
device and no picture is displayed, try
switching the source from one device to
another and back again.
EN
Dali_77_EN_2.indd 28 4/6/2010 11:14:37 AM
Downloaded From TV-Manual.com Manuals