Filter
Top Products
9
English
Note on the power supply lead (yellow)
When you connect other devices to this
circuit is higher than the total fuse value
of all the connected devices.
Notes on speaker connection
Never connect speaker wires to the
metal body or chassis of the car.
Never connect speaker wires with stripes
to one another.
Connect wires: ISO male connectors
Caution
Ensure that all loose leads are insulated with
electrical tape.
Note
Consult a professional to connect CE151 as
instructed below.
1 Connect the supplied male connector to
the unit.
3 Get started
Caution
Use the controls only as stated in this user
manual.
Always follow the instructions in this chapter in
sequence.
model and serial number of your device. The
model number and serial number are on the
bottom of your device. Write the numbers
here:
Model No._____________________________
Serial No.______________________________
Install the car audio
These instructions are for a typical installation.
make the corresponding adjustment. If you have
your Philips car audio dealer.
Caution
This unit is designed for negative ground
(earth) 12 V DC operation only.
Always install this unit in the car dashboard.
Other locations can be dangerous as the rear
of the unit heats up during use.
ensure that the ignition is off.
Ensure that you connect the yellow and red
power supply leads after all other leads are
connected.
Ensure that all loose leads are insulated with
electrical tape.
Ensure that the leads do not get caught under
screws or in parts that will move (e.g.seat rail).
Ensure that all ground (earth) leads run to a
common ground (earth) point.
Use only the supplied mounting hardware for a
safe and secure installation.
professional.
EN