11
EN
Mount into the dashboard
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, make sure that
the bare wires do not touch each
other.
2 Make sure that car dashboard opening is
within these measurements:
3 Install the sleeve into the dashboard and
bendthetabsoutwardtoxthesleeve.
Note
• Ifthesystemisnotxedbysleevebutbythesupplied
screws, skip this step.
183 mm
53mm
5mm
183 mm
53.5 mm
4 Place the supplied rubber cushion over the
end of the mounting bolt.
5 Slide the system into the dashboard until
you hear a "click".
