Philips MCM1120 Car Stereo System User Manual


 
12 EN
5 Load a tape with the open side downward
and the full spool to the left, and close the
tape door.
6 Press to start recording.
» Disc play starts automatically from the
beginning of the disc or the selected
section.
• To pause or resume recording, press .
• To stop recording, press .
Record from radio to tape
1 Tune to a radio station.
2 Pull to open the tape button cover.
3 Press to open the tape door.
4 Load a tape with the open side downward
and the full spool to the left, and close the
tape door.
5 Press to start recording.
• To pause or resume recording, press .
• To stop recording, press .
5 Listen to radio
Tune to FM radio stations
Note
Make sure that you have connected and fully extended
the supplied FM antenna.
1 Press TUNER.
2 Press / on the remote control or
press and hold / on the front panel
for two seconds to tune to a radio station.
3 Whenthefrequencystartstochange,
release the button.
» The FM tuner tunes to a station with
strong reception automatically.
4 Repeat steps 2-3 to tune to more stations.
To tune to a weak station:
Press / repeatedlyuntilyoundoptimal
reception.
Program radio stations
automatically
Note
You can program a maximum of 20 preset radio
stations.
In FM tuner mode, press PROG for 3 seconds
to activate automatic programming.
» [AUTO] (auto) is displayed.
» The unit stores all the FM radio stations
automaticallyandthenbroadcaststherst
preset radio station.