Filter
Top Products
35
14.2 Introduction
14.2.1 General
Programming is carried out using the keys
on the front panel of SM30 Control Centre.
A password must be keyed in via the
programming keys in order to enter a
Programming mode.
Illuminated LEDs on the front panel
indicate which keys can be used at the
current stage of programming.
The left/right arrow keys are used to scroll
through the main menu in order to move to
a different program, and also to move the
cursor during zone routing and relay
assignment.
The double up/down arrow keys are used to
select tens during attention and alarm signal
programming.
The single up/down arrow keys are used to
scroll through selections within an actual
program, and to select digits 1 to 9 during
attention and alarm signal programming.
Pressing BREAK will always return to the
next higher programming level.
Pressing ENTER will confirm your
selection, storing the information in the
system’s memory.
The main menu can always be recognised by
“SELECT PROGRAM:” in the upper line
of the display. Scrolling through the menu
can be done with the left /right arrow keys.
This programming guide assumes that all
possible modules and Call Stations are
present in the system.
14.2.2 User Program
The User Program is a limited version
(programming menus 1 up to 4) of the
Installer Program, detachable at the rear of
the book. This program is intended, as its
name implies, to allow the user(s) of the
system to alter priorities, routing, etc. as
their needs change, without having to call in
expert help. The program contains a variety
of items which are dependent upon the
system configuration.
Programs marked * in the program step list
will only appear on the display if the
relevant modules and/or Call Stations are
present in the system. When a module is not
present in the system the relevant program
step will not be shown on the display.
If the system is in normal operation (in its
‘Run’ mode), the display will show:
* SM30 SYSTEM *
XXXXXXXXX YY
If the Music Input Module is present, the
second display line shows XXXXXXXX as
the current music source name, and YY as
the current volume level (marked, in steps of
3, from 00 to 99).
If the Music Input Module is not present,
the bottom line will be empty.
14.2.3 User Programming Mode
To enter the User Programming mode, type
the correct password: O > ENTER
The display will show:
* SOFTWARE *
* VERSION x.xx *
After a few seconds the display shows:
SELECT PROGRAM:
CALL STATIONS
This is the first program step in the main
menu.
GB/SM 30 user manual 5/26/98 10:18 AM Page 35