Filter
Top Products
37
14.3 User Programming
14.3.1 CALL STATIONS
1.1 Main menu selection
Select from the main menu by means of the
left/right arrow keys:
CALL STATIONS
1.2 Call Station number selection
The cursor will be blinking below the
number of the first Call Station found. The
numbers of Call Stations not present will be
skipped. Selection of another Call Station
can be made using the up/down arrow keys.
1.3 Key Pad Selection
Default is selected the Key Pad of the Call
Station. To program the Function Keys of
the Call Station, select the function key: F1,
F2, F3 or F4 by means of the up/down
arrow keys, and continue with program step
1.8.
1.4 Priority level selection
The display will show the current priority.
Changing the priority level can be done with
the up/down arrow keys. Level 1 is the
lowest; level 9 is the highest priority. (See
chapter ‘System Operation’ for description
of the priority function.)
1.5 Signal number selection
This is the attention or alarm signal that
either precedes a call, or may be used alone.
Signals are selectable using the up/down
arrow keys. Double up/down arrows keys
change the tens, and single arrow keys
change the single numbers.
Signal number “00” means: no signal.
If the selected signal number does not exist,
the display will show:
* NOT EXISTING *
SIGNAL : XX
Pressing any key will return to signal
number selection.
1.6 Pre-recorded Message number
selection
This display will be skipped if the Recorded
Message Module is not present.
The message number can be selected using
the up/down arrow keys.
The sequence of message number selection
on the display is:
0, 1, 2, 3, 4, 1 REPEAT, 2 REPEAT, 3
REPEAT, 4 REPEAT.
“MESSAGE: 0” means: no message. Pressing
BREAK will return to priority level
selection.
See chapter ‘Recorded Message Module’ for
a full explanation, and details of how to
record messages.
1.7 Programming Control Relays
This display will be skipped if the Control
Relay Module is not present in the system.
The current relay programming of Control
relays 1-6 is shown. Shifting the cursor to
the right, further than the last position, will
display the current setting of relays 7-12.
The lower right of the display will show the
relay number which is being indicated by
the cursor. Moving the cursor to a different
relay can be done with the left/right arrow
keys. Relays which are already selected are
indicated by 1, non-selected relays are
indicated by 0. Selecting a relay can be done
with the ‘|’ key. Deselecting a relay can be
done with the ‘O’ key.
GB/SM 30 user manual 5/26/98 10:18 AM Page 37