Philips TDA8566 Car Amplifier User Manual


 
1. General description
The TDA8566 is an integrated class-B output amplifier which is available in several
packages. TDA8566TH is contained in a 20-lead small outline plastic package. The
TDA8566TH1 is a 24-lead small outline plastic package which is pin compatible with the
I
2
C-bus controlled amplifier TDA1566TH for one board layout. TDA8566Q is a 17-pin
DIL-bent-SIL package.
The device contains 2 amplifiers in a Bridge-Tied Load (BTL) configuration. The output
power is 2 × 25 W in a 4 load or 2 × 40 W in a 2 load. It has a differential input stage
and 2 diagnostic outputs. The device is primarily developed for car radio applications.
2. Features
Differential inputs
Very high Common Mode Rejection Ratio (CMRR)
High common mode input signal handling
Requires very few external components
High output power
4 and 2 load driving capability
Low offset voltage at output
Fixed gain
Diagnostic facility (distortion, short-circuit and temperature pre-warning)
Good ripple rejection
Mode select switch (operating, mute and standby)
Load dump protection
Short-circuit proof to ground, to V
P
and across the load
Low power dissipation in any short-circuit condition
Thermally protected
Reverse polarity safe
Protected against electrostatic discharge
No switch-on/switch-off plops
Low thermal resistance
TDA8566TH1 is pin compatible with TDA1566TH
TDA8566
2 × 40 W/2 stereo BTL car radio power amplifier with
differential inputs and diagnostic outputs
Rev. 06 — 15 October 2007 Product data sheet