Filter
Top Products
1
Contents
Connecting the Units ................................ 2
Connecting the power cord (1) .......................... 3
Connecting the power cord (2) .......................... 5
Connecting the System (A) ................................ 6
Connecting the System (B) ................................ 7
VIDEO Input / Output Connection .................. 8
Attaching the Noise Filters ................................ 8
Installation .................................................. 9
DIN Front/Rear-mount ...................................... 9
DIN Front-mount .............................................. 9
DIN Rear-mount .............................................. 11
Fastening the unit to the factory radio
mounting bracket ...................................... 12
CAUTION
• PIONEER does not recommend that
you install or service your display your-
self. Installing or servicing the product
may expose you to risk of electric shock
or other hazards. Refer all installation
and servicing of your display to autho-
rized Pioneer service personnel.
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not drill a hole into the engine com-
partment to connect the yellow lead of
the unit to the vehicle battery. Engine
vibration may eventually cause the insu-
lation to fail at the point where the wire
passes from the passenger compartment
into the engine compartment. Take
extra care in securing the wire at this
point.
• It is extremely dangerous to allow the
display lead to become wound around
the steering column or gearshift. Be sure
to install the display in such a way that
it will not obstruct driving.
• Make sure that wires will not interfere
with moving parts of the vehicle, such as
the gearshift, parking brake or seat slid-
ing mechanism.
• Do not shorten any leads. If you do, the
protection circuit may fail to work
properly.
Connecting the Units