Filter
Top Products
5
Connecting the Units
This product
Power cable
Fuse resistor
Violet / white
Of the two lead wires connected to the back lamp, connect the one
in which the voltage changes when the gear shift is in the REVERSE
(R) position. This connection enables the unit to sense whether the
car is moving forwards or backwards.
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side
of the parking brake switch.
Parking brake switch
Power supply side
Ground side
Connecting method
Clamp the parking
brake switch power
supply side lead.
Clamp firmly with
needle-nosed
pliers.
Note:
• When you have completed lead wire connection,
perform VIDEO SETTING correctly while
referring to the Operation Manual.
• It is necessary to set to [BACK UP CAMERA]
in the [VIDEO SETTING] when connecting the
back-up camera.
Note:
• The position of the parking brake
switch depends on the vehicle model.
For details, consult the vehicle
Owner’s Manual or dealer.
Connecting the power cord (2)
When using this product with a back-up camera, automatic switching to VIDEO video
when the gear shift is moved to the REVERSE (R) position is possible.
Connect the back-up camera to the VIDEO input.
Fig. 3