Filter
Top Products
53
Using the Digital Signal Processor (DSP)
Subwoofer Output (SUB.W)
This product is equipped with a Subwoofer output which can be switched ON or OFF.
Initially, Subwoofer output is ON.
Note:
• You cannot select the SUB.W mode if the preout setting is switched to Rear output mode in the
Initial Setting Menu. (Refer to page 57.)
• Select the OFF setting when you do not want the Subwoofer to operate.
• When the Subwoofer output is ON, the “ ” indicator lights.
Subwoofer Setting Adjustment (80Hz)
When the Subwoofer output is ON, you can adjust the cut-off frequency and the output
level of Subwoofer.
Note:
• You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the
Subwoofer ON/OFF mode.
3. Increase or decrease the output
level with the 5/∞ buttons.
The display shows “+6” – “–6”.
2. Select the frequency to 50 Hz,
80 Hz or 125 Hz with the 2/3
buttons.
1. Press the DSP button and select the Subwoofer setting mode (80Hz) in the
DSP Menu 2.
3. Change the phase of Subwoofer
output with the 2/3 buttons.
2. Switch the Subwoofer output
ON/OFF with the 5/∞
buttons.
1. Press the DSP button and select the Subwoofer ON/OFF mode (SUB.W)
in the DSP Menu 2.