Filter
Top Products
Installing the Unit on a Left-Hand
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 8)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Fig. 8
2. Cut the extra portion of the belt at
the center of the inner holder.
(Fig. 9)
• Keep the cut-off portion of the belt as a spare.
Fig. 9
3. Install outer holder on the inner
holder and secure with screws.
(Fig. 10)
• Tighten the screws with the supplied hexago-
nal wrench.
Fig. 10
4. Install the remote control unit in the
holder. (Fig. 11)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Fig. 11
Release Section
Screw
Outer holder
Belt
Inner holder