Filter
Top Products
55
Others
Troubleshooting
7 Common problems
Symptom Cause Remedy
Power doesn’t switch ON.
The unit doesn’t operate.
Operation with the remote
control isn’t possible.
The unit does not operate
correctly even when the
appropriate remote control
buttons are pressed.
Playback is not possible.
There’s no sound.
If the problem still
remains.
Request repairs.
\
If the problem
remains even after
checking.
Reset the unit. (See
page 6.)
\
If you think there is
something wrong
with the unit.
Before requesting
repairs, check the
following chart.
Leads and connectors are incor-
rectly connected.
A fuse has blown.
Noise and other factors are caus-
ing the built-in microprocessor
to operate incorrectly.
The remote control operation
mode is incorrect.
Battery power is low.
Some operations are prohibited
with certain discs.
The disc is dirty.
The loaded disc is a type this
unit cannot play.
Non compatible video system
disc is loaded.
Connections are incorrect.
With some discs, 96 kHz output
is prohibited.
The unit is performing Still,
Slow Motion or Frame-By-
Frame playback.
Confirm once more that all con-
nections are correct.
Fix the problem causing the
blown fuse, and replace the old
fuse with a new one of the same
capacity.
Press the RESET button. (See
page 6.)
Switch to the correct remote
control mode. (See pages 7, 51
and 52.)
Load new battery. (See page 8.)
Check using another disc.
Clean the disc. (See page 13.)
Check what type the disc is.
Change to a disc compatible to
your video system.
Check connections.
Switch the output setting to
48 kHz. (See page 49.)
There is no sound during Still,
Slow Motion or Frame-By-
Frame playback.