Important points in adjusting cut-off frequencies
• If the subwoofer is installed in the rear tray, setting a high cut-off frequency of L.P.F. of the
subwoofer separates the bass and gives the listener the feeling that the bass is coming from behind.
The L.P.F. of the subwoofer is recommended to be set at 100 Hz or below.
• Speakers used for mid and high-ranges are generally constructed to handle a limited level of input
compared to low range speakers. If the cut-off frequency of H.P.F. is set lower than necessary,
strong bass signals can reach the speaker and may damage it.
Important points in adjusting the level
• The low band, because of its sound frequency characteristics, incorporates the basic frequencies of
many musical instruments. It is recommended that the level adjustment of the low band be made
first, and then the level adjustment of the mid, high, and subwoofer be made in that order.
11. Switch between left and right channel to adjust the filter.
Repeat steps 4 to 10 to adjust the filters of left and right.
10. Press FUNCTION button 4 and
adjust the phase of each band.
Press the button to change between
normal (NOR) and reverse (REV).
Set up the one which makes the better
link to the next band.
9. Press FUNCTION button 3 and
adjust the slope of each filter.
Press the button to change the
adjustment values.
The slope can be set up for either the
high pass filter or the low pass filter.
When setting up, have in mind the
adjustments to be made to the next
band.
8. Press the 5/∞ buttons and
adjust the level of each band.
Holding down these buttons continues
their operations.
Switch to each band and adjust the
level in order to create a better overall
balance.
39
ENG/MASTER 96
39
Audio Adjustment <Network>