Filter
Top Products
13
3.8 Factory recall
When selected 1
st
time a confirmation dialog is shown:
SELECT: Start
EXIT: Back
After selected 2
nd
time, this function sets every option value to the factory-preset value.
After factory recall is finished, the OSD menu is closed and auto adjust is performed for the current mode,
excluding all 31 kHz modes.
3.9 Out of range message
This message starts to move slowly around the screen after 5 seconds. After 5 minutes the monitor
changes to power down mode.
3.10 Resolution notice
When enabled, this message appears when a resolution other than the panel resolution is selected with a
delay of 30 seconds to avoid the message appearing during boot sequence of operating system.
When pressed SELECT, this message is disabled and disappears from the screen. It also disappears after
EXIT is pressed.
3.11 OSD lock / unlock
When the MENU button is pressed during power on and held for 5 seconds, OSD menu is locked and the
message “OSD locked” appears. The message “OSD locked” pops up instead of the OSD menu, when the
MENU button is pressed in OSD lock condition.
To unlock OSD menu, repeat the same procedure as for lock. This opens the OSD menu.
3.12 Power button lock / unlock
To lock/unlock the power on/off button, press up and down button simultaneously (within 0.5 seconds).
The status message “Power button locked / unlocked” appears.
Every time, the power button is pressed in locked condition, the message “Power button locked” appears.
3.13 Service menu
The service menu includes the accumulated operating time (backlight on).