Filter
Top Products
18
DISC TRACK MIN SEC
TROUBLESHOOTING
This CD changer has been manufactured to the specifications of RadioShack and is covered by a limited warranty from
RadioShack. If your CD changer is not operating as it should, take it to your local RadioShack store or call 1-800-THE-SHACK
for assistance.
Your CD changer should give you years of trouble-free service. However, if you do have problems, these suggestions might
help.
Symptom
No sound
When playback is started, it
stops immediately.
Pauses or stops during
playback.
Remote control will not
function.
Cause
• Output cables are connected incorrectly or
loosely.
• Incorrect operation of stereo amplifier.
• Pin plugs and/or amplifier terminals are
dirty.
• Changer is in pause mode.
• The disc is loaded with the label side facing
left.
• Disc is inserted incorrectly.
• Smudges or debris on the disc.
• Dead batteries.
• Obstruction between the changer and the
remote control.
Remedy
• Connect properly.
• Check the settings of the amplifier
switches and sound volume controls.
• Clean away dirt.
• Press 3 or 8.
• Reload the disc with the label side facing
right.
• Insert the disc correctly with the label
side facing right.
• Clean the disc.
• Replace the batteries.
• Relocate the remote control or remove
the obstruction.
SELF-DIAGNOSTICS FUNCTION
Your CD changer has a self-diagnostic function. When the CD changer detects an abnormal condition, it displays an error
number on the display. If this happens, try the suggestion indicated. If the error number still appears, take the CD changer to
your local RadioShack store for assistance.
Display on the changer
Service No.
U1
U2
U3
Unit Status
The disc may not be loaded properly in the
rack.
There is an operation error in the mechanical
section.
There is an error related to the hood.
If the same display reappears, there might be an error in the mechanical section. When requesting servicing, please note
the service number displayed on the changer.
Service No.
Suggestions
• Reload the discs properly.
(Insert only one disc in a slot.)
• Check for foreign matter on the disc.
• Check for foreign matter in the rack.
• Check for foreign matter in the rack.
• Unplug the power cord then plug it in
again.
• Check the hood for clearance and
obstructions.
• Unplug the power cord then plug it in
again.