Filter
Top Products
9
Note: Read this before using the CD changer.
LOADING DISCS INTO THE RACK
• You can load up to 300 discs in the rack.
The numbers marked on the rack are used as the disc
numbers. These are marked in a clockwise order from 1
to 300.
• To load discs beginning from disc Number 1:
Press POWER.
Ensure that the disc Number.
shown on the display is 1.
If disc Number 1 is not dis-
played, press number 1 on the
remote control or the front
panel.
Note: You must perform Step
3
within 5 seconds.
Press UNLOAD.
«
DISC TRACK MIN SEC
The hood opens to the disc
corresponding to the disc
number displayed on the front
panel.
Load the disc into the rack with
the label side (printed surface)
facing to the right.
Note: Inserting more than one disc into the slot will damage
the discs and cause the changer to malfunction.
Turn the jog dial clockwise to
rotate the rack in the direction
in which the disc number
increases (1, 2, 3 ...).
Turn the jog dial counterclock-
wise, to rotate the rack in the
opposite direction.
Load other discs into the rack by repeating Steps
4
and
5
.
Press OPEN/CLOSE to close the
hood.
Tip:
OPEN/CLOSE: The hood simply opens or closes.
UNLOAD:
The slot corresponding to the disc number being
displayed rotates to the center position then the hood opens.
Notes:
• Do not attempt to open the hood with your hand.
• Be careful not to pinch your fingers when opening and
closing the hood.
• If PLAY operation (PLAY, BEST, Hi-LITE, PREVIOUS) is
carried out before disc detection finishes, PLAY operation
proceeds without detection. Detection operates after PLAY
is finished. Detection may not function properly
depending on the color or shape of the disc.
WARNING:
To avoid possible injury or
damage, do not put your hand
or any other object inside the
rack.
• While changing or inserting discs, do not to press any
buttons on the changer or the remote control. The rack
may move suddenly, and could catch your fingers between
discs and the side of the door.
• When changing or inserting discs, make sure the rack is
stopped. Do not attempt to load or remove a disc when
the rack is moving.
• Do not put anything other than CDs inside the rack.
• Load only one disc into each disc slot.
• Do not apply force to the rack.
• You must use an adapter to play 3-inch discs.
• Never start playback by placing the 3-inch disc adapter
alone, without attaching it to a disc.
• The changer will not operate if the hood is opened during
playback.
• To load or remove a disc in or from the slot which is seen
through the hood, press OPEN/CLOSE. The hood opens,
HOLD is displayed. The disc can then be loaded or
removed from the slot. seen through the hood. The rack
can be rotated by pressing DISC(
22
22
2/
33
33
3), even while HOLD
is being displayed.
To remove the discs:
Press UNLOAD.
Select the number of the disc you want to unload by
turning the jog dial or pressing DISC(
22
22
2/
33
33
3) on the
remote control.
• The rack rotates until the selected disc comes to the
front of the changer.
Remove the disc from the rack.
Press OPEN/CLOSE.
• The hood closes.
DISC
SET
0
TRACK
SET
7 8
9
4 5
6
1 2
3
DISPLAY
OPEN/
CLOSE
DISC PUSH
ENTER
HOW TO LOAD THE DISCS
STAND BY
POWER
POWER
301–DISC
CDF
ILE
1
2
UNLOAD
3
4
5
6
7
1
2
3
4