Filter
Top Products
Quick Start
The following steps will help you set up your Expedition XP112a/XP115a loudspeakers.
1. Turn the VOLUME control on the rear panel fully counterclockwise.
2. Set the Contour switch in the out (OFF) position.
3. Turn the Power switch OFF.
4. Connect either a line-level signal from your mixer (or other source) or a microphone
to the Input jack on the Expedition XP112a/XP115a rear panel.
5. Connect the supplied power cable to the IEC socket on the back of the loudspeaker.
Plug the power cable into an AC outlet.
Note: Always make sure that the AC outlet is congured with the correct voltage as
indicated on the rear panel of the Expedition loudspeaker.
6. Switch the Expedition’s Power switch to the ON position.
7. Run an audio signal from your mixer, or talk into the microphone.
8. Slowly raise the Expedition’s VOLUME control until you have reached the desired
level.
9. If the volume from the speakers gets really loud, or you see the Limit indicator
blinking frequently, turn down the VOLUME control on the Expedition XP112a/
XP115a a little until the Peak indicator does not light, or only lights occasionally with
signal peaks.
6