Filter
Top Products
The following steps describes connecting Stereo Line Level Signal to two Expedition
loudspeakers:
• Set the Expedition XP112a/XP115a Power switch to the o position.
• Turn the LEVEL control fully counterclockwise to the o position.
• Connect the power cable to an AC socket.
• Using standard XLR or 1/4” cables, connect the line level signals from a mixer or key-
board into the Expedition Inputs.
• Set the SENSITIVITY switch to the LINE position.
• Switch the Power switch to the ON position.
• Now, run an audio signal from your mixer (like music from a CD) while slowly raising
the Expedition’s Level control until you have reached the desired level.
Connecting a Stereo Signal Source
9Expedition XP112/XP115