Filter
Top Products
63
E N G L I S H
62
E N G L I S H
Troubleshooting
Symptom Check
DVD
•
Check that the TV is set to VIDEO or AV.
•
Check that the video or audio cable is securely connected.
•
Change the “Dynamic Comp.” setting to “On”. This will turn up the
comparatively low volume level of Dolby Digital, which provides the most
wide, dynamic sound range.
Battery pack
•
Check that the DVD player is turned off.
o p e r a t i o n You cannot charge the battery pack with the player turned on.
•
A hot battery pack may take longer to charge.
Wait until the battery pack is sufficiently cooled down.
•
Replace with a fully charged battery pack or use the AC adapter.
•
Replace with a fully charged battery pack or use the AC adapter.
If the DVD player is overheated and the battery pack’s internal
temperature goes up to a certain level, you will not be able to
charge the battery pack.
In this occurs, remove the battery pack. After the battery pack has sufficiently
cooled down, charging will begin automatically.
•
Check that the temperature is within the range of 10
o
C~30
o
C.
•
Check that the DC cord of the AC adapter is Plugged in correctly.
Battery pack
•
Remove the DC cord from the battery pack and then re-plug.
o p e r a t i o n
If the battery pack is installed, remove the DC cord from the battery
pack before performing above procedure.
•
Recharge a different power pack. If the same symptom occurs, your
AC adapter may be defective. If the second battery pack charges without any
problem, your first battery pack may be defective or needs battery replacement.
Video does not appear on
with a external component
connected to the DVD
player
Dolby Digital audio volume
is too low
Battery pack won’t charge
Power does not turn on
Power charge lamp does
not light (Battery pack won’t
charge)
Power charge lamp quickly
flashes Green
Troubleshooting
Symptom Check
No picture
•
Check that the LCD display is turned on.
No sound
•
Check that the display panel is open. If it is closed, audio will not be output to the
speakers.
•
Check the volume setting. If set to zero, turn up volume level.
•
Check that the headphones are plugged into the PHONES and Audio jack. Speakers
cannot be used with the headphones.
No picture and sound
•
Check that the DVD player is in the DVD mode and not in the INPUT mode.
Distorted video or sound
•
Use a disc without scratches or dents.
•
Check that external speakers do not jam the built-in speakers.
While in the input mode,
•
Check that the video or audio cable is securely connected.
no picture is output from
•
Make sure the S-Video cable is used for output only.
the external component
to the DVD player
•
Check that the DVD player is in the INPUT mode and not in the DVD mode.