Filter
Top Products
Connecting the ADN-W AM antenna module to the ADN CU1 central unit
10|ADN-W AM
Connecting the ADN-W AM antenna module
to the ADN CU1 central unit
̈ Use a system cable (supplied with the ADN-W AM; the maximum
cable length allowed is 50 m) to connect the PORT II socket or
PORT I socket of the ADN CU1 central unit to the input
socket of the antenna module.
To optionally combine the antenna module with wired conference
units, connect the antenna module just like a wired conference unit:
̈ Use a system cable to connect the output socket of the
antenna module to the IN socket of an ADN D1 or ADNC1 wired
conference unit.
Or:
̈ Use a system cable to connect the OUT socket of an ADN D1 or
ADN C1 wired conference unit to the input socket of the
antenna module.
If the power supplied to the antenna module via the system
cable is not sufficient (the antenna module does not switch on),
you have to power the antenna module using the NT 12-50C
power supply (see page 6).
Optionally, you can also connect the antenna module to the
PORT sockets of an ADN PS power supply. It does not matter if
you are using a string or ring topology. The antenna module is
connected just like a conference unit to the cable string or cable
ring.
8
9
4
PORT II PORT I
ADN CU1
IN –– AUDIO –– OUT
PORT II PORT I
100-240V~
50/60Hz 240W
2x 52.8V 1.75A
8 9
ADN-W AM
4
3
3
4