Preparing the antenna module for operation
6|ADN-W AM
Connecting the antenna module to the mains power
supply
The antenna module is powered from the ADN CU1 central unit via the
SBC CBL RJ45 system cable.
̈ Connect the hollow jack plug of the NT 12-50C power supply to
the hollow jack socket .
̈ Pass the cable through the cable grip as shown.
̈ Connect the Euro 8 connector of the mains cable to the socket of
the NT 12-50C power supply.
̈ Connect the mains plug of the mains cable to a wall socket.
If the power supplied via the system cable is not sufficient and
if the antenna module is not listed in the central unit‘s oper-
ating menu under “System Menu” > “Versions” > “Hardware
Version Info” or “Software Version Info”:
̈ Use the optional NT 12-50C power supply.
CAUTION
Product damage due to an unsuitable power supply!
If you use an unsuitable power supply, this can cause damage to the
ADN-W AM antenna module.
̈ Only connect the NT 12-50C power supply to the antenna module.
Software Version Info
Main menu
System menu
Versions
No
Hardware Version Info
CU1 SB: 1
ADN PS: 1
AM 1
2
5
EU
UK
US
5
NT 12-50C
2
3
2
2
3