Filter
Top Products
44
ቤ
ቯ
ƽ
ƾ
6 Getting ready
EMP 2015 receiver/amplifier combination
Setting up the EMP 2015
The EMP 2015 is equipped with a temperature-controlled ventilation system.
To ensure sufficient ventilation, please make sure that the ventilation apertures
at the side panels are not covered. An integrated temperature monitoring
device protects the EMP 2015 against overheating by turning it off if the
temperature rises above a certain value. After sufficient cooling, the EMP 2015
is automatically turned on again.
Connecting the antenna and preparing the mains connection
Antenna
Ǡ Connect the supplied telescopic antenna to the BNC socket ƺ at the
rear of the EMP 2015 and lock the bayonet catch.
Ǡ Pull out the antenna and align it.
Note:
For optimum reception, align the transmitting and receiving antenna
vertically.
Mains connection
Ǡ Plug the power cord into socket ƾ at the rear of the EMP 2015.
SK 500 bodypack transmitter
Inserting and replacing the battery
Ǡ Slide the cover of the battery compartment ቤ in the direction of the
embossed arrow until it clicks audibly.
Ǡ Open the cover.
Ǡ Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Ǡ Close the battery compartment.
Ǡ To remove the battery, push the red lever ቯ in the battery compartment
towards the bottom side of the transmitter.
Note:
If powered by a standard PP3 battery, the operating time of the transmitter is
approx. 6 hours. If powered by a rechargeable battery, the operating time is
approx. 4 hours. Special note on rechargeable battery operation: For
optimum operation, only use 9.6 V / 160 mAh NiMH batteries.