Filter
Top Products
ƺ
47
Connecting the loudspeakers
The EMP 2015 has four independent power amplifiers. Therefore, you can
connect up to eight loudspeakers to the EMP 2015 Soundfield System.
When installing a system with up to eight loudspeakers, make sure that
the individual loudspeakers have an impedance from 4 to 8 ohms.
The peak pulse power must be 30 W minimum.
When using more than one loudspeaker, make sure that the individual
loudspeakers have the same polarity (+/–).
Danger of short circuit!
Never connect the loudspeaker cables to the ground and never allow
the cables to come into contact with another cable or metal casing parts.
During operation, the ends of the loudspeaker cables must never come
into contact. This can cause a short circuit and may damage your speaker.
Ǡ Connect a loudspeaker cable to each loudspeaker.
Ǡ Connect each loudspeaker separately to the amplifer. Do not connect in
“daisy-chain” configuration.
Ǡ Connect one loudspeaker to each loudspeaker output ƺ.