Filter
Top Products
7
Selected item Description
Yes
Select “Yes” when your antenna is set-
up and connected independently.
No
Select “No” when you do not need to
supply voltage to your antenna, i.e.
when your antenna is connected to
a community antenna. (The factory
default setting of this function is “No”.)
Initial auto installation
When the TV powers on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
1
Press POWER on the TV.
• The initial auto installation wizard appears.
2
Press
c
/
d
to select “HOME” or “STORE”,
and then press ENTER.
Press
c
/
d
to select your country channels
listed on the screen, and then press ENTER.
Press
a
/
b
/
c
/
d
to select “DTV”, “ATV” or
“ATV + DTV”, and then press ENTER.
Press
a
/
b
to select the desired sound
system, and then press ENTER.
• Sound system is selectable when the signal search
is set to “ATV” or “ATV + DTV” mode only.
• Auto installation will be executed.
• You do not need to do anything during the auto
search.
• HOME: “STANDARD” will be the default value for
the “AV mode” setting.
• STORE: “DYNAMIC (FIXED)” will be the default
value for the “AV mode” setting. If the “AV mode”
is changed, the TV will automatically switch back
to “DYNAMIC (FIXED)” when there is no further
change to TV setting for 30 minutes.
• To change the STORE mode to HOME mode,
please refer to page 14 to reset the unit.
Checking Signal
information
If you install a DVB-T antenna for the fi rst time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Digital programme
setup”, and then press ENTER.
Turning the TV on/off
Turning on/off the power
• To turn on the power
Press POWER on the TV. (After a few seconds, an image
appears with sound.)
• To turn off the power
Switch it off by pressing POWER on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby by
pressing POWER on the remote control.
• Switching on from standby
From standby, press POWER on the remote control.
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby mode.
Supplying electric
power to the antenna
When you set-up the DTV antenna for the fi rst time, or
connect the antenna to a community antenna, you need
to proceed to set the antenna by following this manual.
1
Press DTV to access DTV mode.
2
Press MENU and the MENU screen displays.
3
Press
c
/
d
to select “Setup”.
4
Press
a
/
b
to select “Digital programme
setup” and then press ENTER.
5
Press
a
/
b
to select “Antenna power” and
then press ENTER.
6
Press
c
/
d
to select “Yes” and then press
ENTER.
LC32L400X_pg01-09_EN.indd 7LC32L400X_pg01-09_EN.indd 7 29/07/10 10:15:30 AM29/07/10 10:15:30 AM