Filter
Top Products
10
Turning the TV on/off
Turning on/off the power
• To turn on the power
Press POWER on the TV. (After a few seconds, an image
appears with sound.)
• To turn off the power
Switch it off by pressing POWER on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby
by pressing POWER on the remote control.
• Switching on from standby
From standby, press POWER on the remote control.
NOTE
• If you are not going to use this TV for a long period of time, be
sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby mode.
Initial auto installation
When the TV powers on for the first time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
1 Press POWER on the TV.
• The initial auto installation wizard appears.
2 Press a/b to select your country channels listed
on the screen, and then press ENTER.
Press a/b to select “HOME” or “STORE”, and
then press ENTER.
HOME:
• “STANDARD” will be the default value for the “AV mode”
setting.
STORE:
• “DYNAMIC (FIXED)” will be the default value for the “AV
mode” setting. If the “AV mode” is changed, the TV will
automatically switch back to “DYNAMIC (FIXED)” when
there is no further change to TV setting for 30 minutes.
• The confirmation screen appears only when selecting
“STORE”.
Press a/b to select “Yes” or “No”.
• To change the STORE mode to HOME mode, please
refer to page 16 to reset the unit.
Press a/b to select “DTV”, “ATV” or
“DTV + ATV”, and then press ENTER.
• Auto installation will be executed.
• You do not need to do anything during the auto search.
Checking Signal information
If you install a DVB-T antenna for the first time or relocate
it, you should adjust the alignment of the antenna to
receive a good reception while checking the antenna
setup screen.
ATV/DTVATV
/
DT
V
1 Press MENU and the MENU screen displays.
2 Press c/d to select “ ” (Programme setup).
3 Press a/b to select “Digital setting”, and then
press ENTER.
4 Press a/b to select “Signal Information”, and
then press ENTER.
• The “Signal Information” screen will appear.
LC60LE650X_EN_book.indb 10LC60LE650X_EN_book.indb 10 7/18/2013 8:52:21 AM7/18/2013 8:52:21 AM