Filter
Top Products
31
Protection against overturning
There is a danger of the product overturning in the case
of a disaster or sudden collision. Carry out the following
tip-resistant measurement for your safety.
Anchoring the TV to the wall or a pillar
1 Affix the TV to the wall or a pillar using extra strong
ties and cup hooks.
Cup hook (commercially available)
Tie (commercially available)
Fixing the TV to the table
1 Place the TV on the table.
2 Pull the attached restraining bracket out so that it
is at a 90 degrees angle.
3 Insert commercially available screws in the holes
of the restraining bracket and tighten the screws
to secure the TV to the table.
• Use commercially available screws to firmly secure the
TV.
Stand
Screw (commercially available)
Restraining bracket (attached)
CAUTION
• As this product is heavy, use a table that is wide
enough to support the product and capable of
withstanding the product’s weight. The table should be
set where it will not be overturned.
• Be sure to use at least two people when moving the TV.
Removing the stand
For wall mounting with the bracket remove the stand.
Before setting TV on the wall
• Remove the connected cables (DVD, VCR, etc) from the
terminals.
• Detach the four caps at the 4 locations on the rear of the TV.
1 Unfasten the screws at the 4 locations on the rear
of the stand.
2 Detach the stand from the TV (hold the stand so it
will not drop from the edge of the base area).
NOTE
• To attach the stand, perform the above steps in reverse order.
• As the TV is very heavy, be careful when moving it.
LC60LE650X_EN_book.indb 31LC60LE650X_EN_book.indb 31 7/18/2013 8:52:24 AM7/18/2013 8:52:24 AM