Filter
Top Products
24
PC Control of the TV
• When a programme is set, the TV can be controlled
from the PC using the RS-232C terminal.
The input signal (PC/video) can be selected, the
volume can be adjusted and various other adjustments
and settings can be made, enabling automatic
programmed playing.
• Attach an RS-232C cable cross-type (commercially
available) to the Din/D-sub RS-232C for the
connections.
NOTE
• This operation system should be used by a person who is
accustomed to using PCs.
Communication conditions
Set the RS-232C communications settings on the PC
to match the communications conditions of the TV. The
communications settings of the TV are as follows:
Baud rate:
9,600 bps
Data length:
8 bits
Parity bit:
None
Stop bit:
1 bit
Flow control:
None
Communication procedure
Send the control commands from the PC via the
RS-232C connector.
The TV operates according to the received command
and sends a response message to the PC.
Do not send multiple commands at the same time. Wait
until the PC receives the OK response before sending the
next command.
Command format
Eight ASCII codes e CR
C1 C2 C3 C4 P1 P2 P3 P4
Command 4-digits Parameter 4-digits Return code
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0 – 9, space, ?
Parameter
Input the parameter values, aligning left, and fill with
space(s) for the remainder. (Be sure that four values are
input for the parameter.)
When the input parameter is not correct, “ERR” returns.
(Refer to “Response code format”.)
a 30
0009
0
Response code format
Normal response
OK
Return code (0DH)
Problem response (communication error or incorrect
command)
ERR
Return code (0DH)
LC60LE650X_EN_book.indb 24LC60LE650X_EN_book.indb 24 7/18/2013 8:52:23 AM7/18/2013 8:52:23 AM