Filter
Top Products
[ Installation ]
23
antenna cable in a location where it can be hidden. Connect the antenna cable to the ANT
connection at the rear of the vehicle dock. (Refer to Figure 12 on page 24 for the location of
this connector.)
Once the antenna cable is routed through the vehicle, and you are satisfied with the cable
routing, peel the protective material from the adhesive strips and press the rubber antenna
cable cover/tail firmly into place on the vehicle. Double check that the location of the antenna
and rubber antenna cable cover/tail are correct, and continue to press firmly down on rub-
ber antenna cable cover/tail for another 30 seconds. (Figure 11) At room temperature (68
degrees), maximum adhesion usually occurs within 72 hours. During this period, avoid car
washes and other contact with the antenna and rubber antenna cable cover/tail.
Figure 11Figure 11