Filter
Top Products
Getting Started
17
Getting Started
Setting Up the Channel List - Initial Setup
After you finish connecting your TV, you need to run Initial Setup, which
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time. If you do not want to set up the
channels at this time, you can do it later by selecting the Auto Program
option in the Analog and Digital Setup settings (see pages 35 and 36).
1 Press to turn on the TV.
The Initial Setup screen appears.
2 Press V/v to highlight the on-screen display language. Then press .
The message “First please connect cable/antenna. Do you want to start
Auto Program?” appears.
3 Press B/b to highlight “OK” then press .
The message “Auto Program” appears. Then the message “Continue
programming digital channels?” appears. This may require 50+ minutes
for completion.
4 Press B/b to highlight “OK” then press .
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on pages 35 and 36.
To add individual digital channels
❑
Use the Digital Channels feature as described on page 36.
The default setting for channel selection is Cable On. For antenna
connections, run the Auto Program again after selecting Cable Off from
the Setup settings.
If you selected “Cancel” during the Initial Setup, the Initial Setup
message will appear each time you turn on the TV as a reminder until
you complete the Auto Program.
POWER