Toshiba P500 Car Satellite Radio System User Manual


 
208
If Something Goes Wrong
Develop good computing habits
Cannot use the “USB Sleep and Charge function.”
The setting of “USB Sleep and Charge function” may be
Disabled. Change the setting to Enabled.
Some external devices may not be able to use the “USB Sleep
and Charge function.” In this case, please try one or more of
the following methods.
Change the Enabled mode setting.
Turn OFF the computer while external devices are
connected.
Connect external devices after turning OFF the computer.
If this function cannot be used, change the setting to Disabled.
Make sure that you are connected to a compatible port.
The “USB Wakeup function” does not work.
When the “USB Sleep and Charge function” is set to Enabled
the “USB Wakeup function” does not work for ports that
support the “USB Sleep and Charge function.” In that case, use
a USB port that does not have the “USB Sleep and Charge
function”-compatible icon ( ), if you have a non-Sleep and
Charge USB port available or disable the “USB Sleep and
Charge function.” For more information, see “USB Sleep and
Charge Utility” on page 168.
The eSATA device is not recognized from Sleep or
Hibernation mode.
A connected eSATA device may not be recognized if it is connected
to the computer’s eSATA/USB combo port while the computer is in
Sleep or Hibernation mode. If this occurs, disconnect the eSATA
device and then reconnect the device while the computer is turned
on.
Before connecting the eSATA device to your computer and external
power source, read the documentation that came with the device and
follow the manufacturer’s instructions.
NOTE