Filter
Top Products
P1005089 Rev. C pg. 7 of 13
11.00"
8.63"
2.01"
2.75"
1.82"
0.31"
0.31" Dia. x4
0.31"
Figure 3
Mounting Bracket Hole Layout (not to scale)
Note that using a MM4 Mobile Mount assembly in the horizontal configuration requires
leaving a minimum access for printer controls from any overhanging horizontal surface.
(Refer to Figure 2).
CAUTION: Do not use the circular cutouts in the Mounting Bracket as the only mounting point
when using in the horizontal conguration.
Hardware to secure the Mobile Mont to the vehicle is not supplied in the kit. Recommended
fasteners are 1/4” (6 mm) diameter hex head or socket head bolts with at washers, lock washers,
nuts and/or locking nuts.
8.63”
(21.92 cm)
2.75”
(6.98 cm)
ø.31” x 4
(7.8 mm)
11.00”
(27.94 cm)
2.00”
(5.08 cm)
31” typ.
(7.8 mm
1.82” typ.
(4.62 cm)
.31”
(7.8 mm)