1. Introduction
5
Rear Panel
No. Component Description
1 Power Switch A rocker switch to power the system on and off.
2 Console 3 and 4
Connectors
Use KVM Cable sets (see Cables, page 3), to connect the
components that make up Consoles 3 and 4 to these ports.
3 Power Jack The power adapater cable plugs in here.
4Console 2
Microphone and
Speaker Jacks
The microphone and speakers belonging to Console 2 plug
in here.
5 Console 2 KVM
Connectors
The keyboard, monitor and mouse belonging to Console 2
plug in here.
6Console 1
Microphone and
Speaker Jacks
The microphone and speakers belonging to Console 1 plug
in here.
7 Console 1 KVM
Connectors
The keyboard, monitor and mouse belonging to Console 1
plug in here.
8 KVM Port
Section
Use KVM Cable sets (see Cables, page 3), to connect
computers or cascade additional KVM switches (see
Cascaded Installation, page 9) to any available port.
4
1
2
3 75 86
cs428_2007-05.book Page 5 Thursday, May 17, 2007 5:08 PM
