4. OSD Operation
23
(Continued from previous page.)
Setting Function
SCAN DURATION Determines how long the display dwells on each port when it
cycles through the selected ports in Quick View Scan Mode.
Key in a value from 1 - 255 seconds, then press [Enter].
Default is 3 seconds.
PRIVATE MODE The [Enter] key is a toggle that Enables/Disables Private
Mode for the currently selected port. When Private Mode is
Enabled, none of the other Consoles cannot access the port,
and their monitors show a blank screen when they come to it.
If another console tries to access the port, the message:
Private Mode: Console x (where x represents the number of
the console that has set private mode for the port), displays
on its screen.
When you have finished making your selections, press [Esc]
to return to the OSD Main Menu.
RESTORE DEFAULT
VALUES
This function is used to undo all User changes and return the
setup to the original factory default settings - except for the
Names that were assigned to Ports, which are retained.
MOUSE BUTTON
SETUP
This function allows you to set the mouse for right or left
handed operation. Use [Enter] to toggle between the two.
SET PASSWORD This function is for Users to set their passwords:
1. When you access this function, if you already have a
password you must enter it in order to continue.
2. A screen appears that allows you to key in your new
password. The password may be up to 8 characters long,
and can consist of any combination of letters and numbers
(A - Z, 0 - 9).
3. To modify or delete a previous password, use
[Backspace] to delete the characters.
4. Key in the password, then press [Enter]. You are asked to
key the password in again, in order to confirm that it is
correct. Key in the new password again, then press
[Enter].
If the two entries match, the new password is accepted. If
the entries do not match, you must start again from the
beginning.
cs428_2007-05.book Page 23 Thursday, May 17, 2007 5:08 PM
