A SERVICE OF

logo

Open as PDF
next previous
Appendix
67
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted or you have forgotten it, for
example) you can clear the login information with the following procedure:
1. Power off the KH2508
A / KH2516A and remove its housing.
2. Short the jumper labeled J8.
3. Power on the switch.
The on screen display will show a message informing you that the
password information has been cleared.
4. Power off the switch.
5. Remove the jumper cap from J8.
6. Close the housing and start the KH2508
A / KH2516A back up.
After you start back up, you can use the default Username and Password (see
OSD Overview, page 23) to log in.