A SERVICE OF

logo

Open as PDF
next previous
95
8.4 Command Control via the Network
<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&
commands.
Communication Port
The following two ports are assigned for the command control.
Command Control Settings (
44)
4) Click the [Enable] check box to open Network Control Port1 (Port: 23) to use
7&3&OLFNWKH[Enable] check box for the [Authentication] setting when
authentication is required, otherwise clear the check box.
5) Click the [Enable] check box to open Network Control Port2 (Port: 9715) to
XVH7&3&OLFNWKH[Enable] check box for the [Authentication] setting
when authentication is required, otherwise clear the check box.
6) Click the [Apply]EXWWRQWRVDYHWKHVHWWLQJV
&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter “http://192.168.1.10/” into the address bar of the web browser, and select
Projector Web Control from the selection window.
2) Enter your user name and password, and then click the [OK].
3) Click the [Port Settings] on the main menu.
8. Other Functions
7&3(Network Control Port1 (Port: 23))
7&3(Network Control Port2 (Port: 9715))
&RPPDQGFRQWUROLVDYDLODEOHRQO\YLDWKHVSHFL¿HGSRUWDERYH
NOTE