25
DFW-SX900
DFW-X700
SETTINGS OF CAMERA CONTROL AND STATUS REGISTER
CSR F0F0080Ch White Balance
Adjust the red and blue gains to capture white subjects in color properly. Two types of automatic adjustment modes are
available.
NOTE
: If the CSR F0F00830h Trigger is set to ON or if the CSR F0F0081Ch Shutter setting is less
than 800h, the Auto function cannot be used.
The CSR F0F0088Ch Optical Filter is canceled by this command. (Priority to latter)
(1) Manual adjustment
Command = 820mm0nnh mm: Adjust B-gain in the range of 00h (min) – FFh (max).
nn : Adjust R-gain in the range of 00h (min) – FFh (max).
80h is the standard value.
(2) One-Push Auto White Balance
Perform automatic adjustment when command is received to maintain the white balance at that time.
Execute: Command = 86∗∗∗∗∗∗h ∗∗∗∗∗∗: Undefined
When this operation is complete, the command is read out as 82∗∗∗∗∗∗h (∗∗∗∗∗∗: Undefined).
NOTE
: Execute after capturing a white subject lit using the light source used for shooting
over the whole screen at the appropriate exposure. It will take 10 seconds at
maximum to complete automatic adjustment.
Execute again if the light source used for shooting has been changed.
(3) Auto Tracing White Balance
Perform automatic adjustment continuously to trace the white balance according to changes in the shooting
conditions.
Execute : Command = 83∗∗∗∗∗∗h ∗∗∗∗∗∗: Undefined
Stop : Stop operations according to the following rules.
q Read out the CSR F0F0080Ch.
w Write the manual adjustment command at the value read out.
820mm0nnh
Set the values read out for mm, nn.
NOTE
: Operations stop if the exposure is inappropriate.
