Hooking up Components
11
GB
Before performing the initial setup procedure,
be sure to perform the following operations.
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.
Before you use your remote
Inserting batteries into the
remote
Insert two R6 (size AA) batteries with the
polarity (+ and –) properly oriented in the
battery compartment.
Tip
Under normal conditions, the batteries should last for
about 6 months. When the remote no longer operates
the control center, replace both batteries with new
ones.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor of the control
center to direct sunlight or lighting apparatuses.
Doing so may cause a malfunction.
• When not using the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
• Turn off the power to all components before making
any connections.
• Be sure to make connections firmly to avoid
humming and noise.
About the remote operation
• The instructions in this manual are described
using the controls on the remote. You may
also use the controls on the receiver if they are
of the same or similar name as those on the
remote.
• The initial settings are underlined.
Performing initial setup
operations
Before using the receiver for the first time,
perform the initialization procedure as follows.
This procedure can also be used to return
settings you have made to their factory defaults.
Press ?/1 while pressing 2CH. When
“CONFIRM” appears, press 2CH again.
The following items are reset or cleared:
• All sound field parameters
• All parameters in the SET UP, LEVEL and
TONE menus
• Sound fields memorized for each program
source
•Preset stations
Further, the master volume is set to the
minimum value.
Before performing the
initial setup
b
To a wall outlet
AC power cord
