A SERVICE OF

logo

Using the supplied remote
41
GB
You can switch the command mode (AV1 or
AV2) of the remote. If the command mode of the
receiver and the remote is different, you cannot
use the remote to operate the receiver.
Press AV1 (or AV2) while holding down RM
SET UP P .
RM SET UP P lights up once, then the
command mode switches.
To reset the remote to factory
settings
Press ?/1, AV ?/1, and MASTER VOL – at
the same time. RM SET UP P lights 3 times,
then goes off.
Selecting the mode of the
remote